What's new
By:
Filters

Zgemmas h2s stuck on red light

N

nitro123

Newbie
Hi guys my zgemma h2s is stuck on red light with on digital display I tried flashing it with different usb sticks I bought two new sticks and still no luck I know there is no bootloader for these boxes any help will be very much appreciated. Thanks
 
Try a small sandisk usb stick & do a low format, Then check the files within the H2S folder, and if there is one that says noforce.then change it so see if it helps [ sometimes in can make a difference ] & also try holding the power button when it first starts up....
 
Last edited:
wullboy said:
Try a small sandisk usb stick & do a low format, Then check the files within the H2S folder, and if there is one that says Force.then change it so see if it helps [ sometimes in can make a difference ] & also try holding the power button when it first starts up....
Click to expand...


Hi @wullboy which small gig sandisk usb shall I get ? No there is not a folder in it that says force. I tried the power button yesterday pressed all remote buttons and nothing. Thanks
 
A 2/4 gb sandisk should be ok, If you look in your H2s image folder, there are 4 files [ i do believe ] 1 of them will be " NO FORCE " rename it to " force " .......but doesn't the H2S model not require you to hold the power button down when flashing ?? Also, use the back usb port, and remove anything else that may be attached to the box...
 
I removed the noforce and replace it to force and no joy I used this usb stick before lots off times to flash zgemma sandisk. I pressed the front power button on box and nothing still still getting red light. Anymore tips ?
 
I had a stick, that i had used on 3 zgemma to flash a new images onto them, i try to reuse it on one of the original boxes that had failed, and it would not look at it, i did a FULL reformat on the stick, put the original image back on to the stick, and it did eventually flash the box, Just keep trying m8...
 
You must log in or register to reply here.
Back
Top