Dm800 error help

jevo99

Newbie
this is my device and versions from the web app prior to the error


Devicename:dm800Enigma


Version:ramiMAHER.-experimental


Image Version:Newnigma2-Release-2010-11-14


Frontprozessor Version:VNone


Webinterface Version:1.6.2


I used the enigma2 panel on my image to preform updates but after I rebooted my box I keep getting an error * ERR01 : NO CA FOUND
this error prevents my box from booting ?

Thank you for your help
 
You need to reflash your box using a rs232 cable , if you can't connect using normal dream up then look for the modified dream up which will connect , then find the right software for your box version/sim . If you load the wrong software you will receive the same message.
best bet is to buy original dreamboxs and not the cheap clone crap ,
 
use 2nd stage dreamup loader(DreamUP_patched_by_forhike_and_natas) when through rs232 cabel box connected press (DM800_repair) then flash your box when image file installition complete type ip in explorer then install boot loader and press ok on reboot at explorer.
 
Last edited:
Back
Top