Multiple lines

[siri_uk]

Hi guys

I currently have 2 lines, one in cccam and one running on mgcam, I've just bought a vu+ solo 4k that only uses oscam. Is there any way to have the 2 lines running in oscam or any way to alternate between them.

TIA

Sent from my SM-G955F using Tapatalk

 

[Janso]

Yes, you can convert both to Oscam.


Sent from my iPhone using Tapatalk

 

[dangerous]

Hi guys

I currently have 2 lines, one in cccam and one running on mgcam, I've just bought a vu+ solo 4k that only uses oscam. Is there any way to have the 2 lines running in oscam or any way to alternate between them.

TIA

Sent from my SM-G955F using Tapatalk

Both will run in oscam
There's a couple of set up guides for oscam on this site.
One for openvix and one for open ATV.
If you take a look in my signature strip there's a link to a guide I made with reference to setting up oscam for open ATV.

 

[siri_uk]

Thanks for the replies guys, I've put both lines in as readers on group 1 and group 2, set 2 dvbapi users on groups 1 and 2 dunno if it's right but seems to be working

Sent from my SM-G955F using Tapatalk

 

[grog68]

When I switched to oscam the only file I edited was oscam.server, and it contains the following :

[reader]
label = Oscam Line cable
enable = 1
protocol = newcamd
device = SERVER_ADDRESS,SERVER_PORT
key = 0102030405060708091011121314
user = USERNAME
password = PASSWORD
fallback = 1
group = 1

Sorry not sure how a c line needs to be entered.

Also when I had my vm super hub 3 installed I found oscam failed for some reason so I installed oscam_emu and it works flawlessly.