Oscam

havhttps://linuxsat-support.com/thread/31976-how-to-configure-oscam-to-use-as-cccam-client/e a look here
 
I found the easiest way into the Oscam settings was to use a browser to log in to the VUSolo4K directly.
You need to be on an encrypted channel and ensure oscam is selected as your cam (menu/infopanel/softcam Panel on my whooshbuild setup)
Find your VU receivers IP address (menu/setup/system/network/device setup/lan or WiFi/adapter settings)
On a PC internet browser go to to your receivers IP address and add the port :8888 (ie:http://192.168.0.5:8888) If this address not found Oscam is not running!
At the top of the page click on 'Readers' and then 'Add Reader'
Give it any name where it says 'NEW Reader Label:' and a protocol (usually ccam or newcamd) Press 'Add'
In the box that comes up in 'Device' put your server address and port (ie. anyserver.xyz, 12345) Click 'Enable' box
Scroll down and enter User and Password in the boxes.
Scroll down and click 'Save'
Your line should now start working.

Good Luck. Also useful for editing lines and other settings in the VU Solo 4K.
 
Ive got a solo se v2 with vix running on it, and port :8888 does not work, i have to use :9000..
 
Can it be changed from :9000 to :8888 in the config file, as i see it in there ?? or is it embedded..
 
Back
Top