VU duo

Noste500

Member
if I run my box with 2 channels as sat and 2 as cable
Where do I put my cable line ?
It’s currently set up as sat on all 4 channels , do I need to download any other cams or other files to set up ?

It’s on vix currently.

I will prob just turn off the sat tuners for now until the cable is working ok ,
Thanks
 
It’s a duo 2 and I have a twin cable tuner arriving 2mw.
So I will replace one of the twin sat tuners with the twin cable tuner .
 
Put the two lines inside the same newcamd.list file

Www......... username password 1 2 3 4 5 6 7 8 9
Www.......... username password 1 2 3 4 5 6 7 8 9

Similar to that
 
My sat line ( which has expired ages ago ) was an N line and I ran mgcamd
Do I use a cable N line and run mgcamd with this ???

Not run cable before , only sat , so it’s all new to me .
 
My sat line ( which has expired ages ago ) was an N line and I ran mgcamd
Do I use a cable N line and run mgcamd with this ???

Not run cable before , only sat , so it’s all new to me .

Yes you can use CWS line in newcamd.list and then use mgcamd softcam with VM line
you'll also need to set your netid for your area and run a scan for channels in autobouquetmaker
 
watch this and you'll need to go to tuner config, set it to virgin uk and put the netid in there
then go to to autobouquetsmaker and run a scan
 
I was already looking at the bees setup .
I think I will have to do a fresh build as I cannot get to put my net Id in ....
 
Back
Top