Vu+ Solo se v2 dead after failed update

Nope it’s just stuck in a loop
de8ac24b4da287420bb37a7d3010c025.jpg



Sent from my iPhone using Tapatalk
 
any image flashed will give you the wizard to setup box with first use,exit and exit and exit to go backwards?
 
Just flashing it with the factory image and see if that’s any different if not I’ll have another go tommorow


Sent from my iPhone using Tapatalk
 
It’s still under warranty so I’m going to give them a ring today, thanks for the help [emoji106]


Sent from my iPhone using Tapatalk
 
do you get the splash screen on tv also,if you do box is giving out a signal as no hdmi output will give a blank screen and using remote would not see any change?
 
Splash screen? What’s that? The only image I see is a vu+ Linux logo for about 2 seconds and then nothing


Sent from my iPhone using Tapatalk
 
Post 27 shows 'mode at 1080p' and refresh rate at '60hz' maybe your tv wont support that...... try 'mode 1080i' and 'refresh rate 50hz'
 
Last edited:
Back
Top