VU+SOLO SE V2 HELP NEEDED!!

shadybhoy

Newbie
hey guys. looking for some help here. i bought a vu+solo se v2 from wos with vix pre intalled.
single feed (virmin) going in. followed bee's guide got my fta channels. used filezilla to swap flies onto box swapped over my CCcam.cfg file on filezilla instead of newcam as my line is cline. put the green ticks against cccam.2.3.0 and mgcamd.1.38 on box but still have no $ channels
 
the for reply. im trying to run only CCcam.2.3.0 in softcam manager when i try to start it says "no config files found please setup CCcam first in /etc/CCcam.cfg
so i went back to filezilla and check to see if the CCcam.cfg was on right hand side and it was......thats where im at now
 
There's an issue with the receiver reading the CCcam.cfg file then.

Check there is no added test to the end of the file name
 
nothing at the end. once it over to right hand side of filezilla it that it uploaded or do i need to press anything else?
i have no idea how to add a screenprint on here or i would show a pic of cccam.cfg on the right hand side
 
Back
Top