What's new
By:
Filters

Wooshbuild on h2

B

B1g B1ll

Newbie
Installed wooshbuild but can't get in to configure it to run on just cable as it doesn't give me the option in autobouquets as it just says 28.2e
Am sure I saw a thread about editing something using filezilla but can't find it
Any help much appreciated

Sent from my SM-G935F using Tapatalk
 
I don't have that option in abm
As the abm is e2 for 28.2e only so can't change it to vm and don't know where to change it from or am missing something
Sorry for the copied question as I knew I'd written it but couldn't find it to check for replies

Sent from my SM-G935F using Tapatalk
 
I see, you have AutobouquetsE2 instead of ABM - you need to remove this and install ABM to scan for cable.
 
Found it the tunner went to not configured hopeful ok now
Cheers for your help

Sent from my SM-G935F using Tapatalk
 
You must log in or register to reply here.
Back
Top