What's new
By:
Filters

Zegemma with grog build installed how to uninstall and put whoosh build on it

E

emmerdale

Member
Hi guys i have a zgemma h5.2tc box that came with grog build on it i would like to uninstall it and install whoosh build on it . i have been into setup but can not find a reset to factory settings on it anybody know how i can uninstall it or can i over write it any halp would be apreciated.
 
Make a note of box ip address Just reflash with open atv 6.2 downloadeded from openatv nightly builds then select air digital your box model will be in there download 1 of the zip files extract zip file open zgemma folder if there is a file that says no force rename to force power box completely off put zgemma file onto USB and insert into box turn box and and should flash when gets to hdmi setting put remote down and go onto putty enter your box ip address press connect will say login as type root press enter then enter this command opkg install http://wbuildx.co.uk/setup.ipk then press enter and infinity will install
 
if you press the blue button on your remote you will see a 'flash online' option on the right hand side of the menu, select this and follow instructions to flash box. now run the wb setup.
 
Thanks guys i did as you said and i flashed it. but i have noticed there are no mg camds in the box and can not find any in the plugins. is there anywhere i can get these from thank you
 
Press 3 lines at top of page go to resources and download the universal softcam feeds ipk put onto USB and follow onscreen instructions once installed give box a reboot and should be in plugins
 
On a fresh install of infinity run these 3 commands using terminal or putty

This one installs the softcam feed

wget -O - -q http://updates.mynonpublic.com/oea/feed | bash

This one installs e2istream (replacement for e2iplayer)

wget http://www.softrix.co.uk/istream/installer.sh -O - | /bin/sh

This one gets rid of all the German default bouquets plus all other bouquets

init 4 && sleep 10 && rm -f /etc/defaultsat.tar.gz && rm -f /etc/enigma2/lamedb && rm -f /etc/enigma2/*.tv && rm -f /etc/enigma2/*.radio && rm -f /etc/enigma2/*.del && init 3

When you run the last command your box will restart.
When its booted press menu > setup > reception > autobouquetmaker and start a scan to bring the bouquets back

Once you have your channels back you can go and install the cams needed
 
Last edited:
You must log in or register to reply here.
Back
Top