My ZGemma started rebooting all the time and it was driving me crazy. I tried to reflash with various images.
Then I had a brain wave, I read in a thread somewhere that the cables might be suspect. I checked they were all connected properly.
I decided to change over to another power supply I had sitting in the drawer. Perfect it is now running 100%
Hope this help some of you out there.
Just as a foot note I thought about this because I had once put an under power power (1 amp) supply to my CCTV DVR and it would not see my hard drive. Only when I replaced it with a 2 amp supply did my CCTV DVR see the hard drive.
Never throw old power supplies out and double check your equipment is being supplied by a stable and correct power supply.
Then I had a brain wave, I read in a thread somewhere that the cables might be suspect. I checked they were all connected properly.
I decided to change over to another power supply I had sitting in the drawer. Perfect it is now running 100%
Hope this help some of you out there.
Just as a foot note I thought about this because I had once put an under power power (1 amp) supply to my CCTV DVR and it would not see my hard drive. Only when I replaced it with a 2 amp supply did my CCTV DVR see the hard drive.
Never throw old power supplies out and double check your equipment is being supplied by a stable and correct power supply.