Zgemma h5.2tc pausing issue

[shoaib7062]

Setup my zgemma with wooshbuild and this runs smoothly. However if the box remains on for 1+ hours, the pause function doesn’t work. Just shows the x symbol. Restarting the box fixes it for a bit but then it happens again. During the issue, recording is fine and anything else relating to the hdd also. This hasnt been happening before so not sure what has caused it.

Any help will be appreciated

 

[gray1313]

Setup my zgemma with wooshbuild and this runs smoothly. However if the box remains on for 1+ hours, the pause function doesn’t work. Just shows the x symbol. Restarting the box fixes it for a bit but then it happens again. During the issue, recording is fine and anything else relating to the hdd also. This hasnt been happening before so not sure what has caused it.

Any help will be appreciated

is your hard drive or usb set to media/hdd in the mounts section