they may not have been lose but could still have a fault I would still try new cables or you could even check PCB for loose solder joint.i did, cables were not loose, but so far hard drive connected to usb port working fine, fingers cross.
they may not have been lose but could still have a fault I would still try new cables or you could even check PCB for loose solder joint.i did, cables were not loose, but so far hard drive connected to usb port working fine, fingers cross.
Glad you have found a solution.i did, cables were not loose, but so far hard drive connected to usb port working fine, fingers cross.
No everything will remain the same if you don't use the HD for anything else while its removed.If i remove zgemma h7s box remove hardrive will i have to initialise harddrive again