Zgemma infinity VMode options

[abp1873]

Is there anyway to change the video resolution when using infinity ? as an example on the older versions of wooshbuild when you switch to say a channel showing an older programme like Frasier , everybody loves Raymond etc the picture on TV shows as two black bars on each side. When you press VMode on remote on older wooshbuild you get the auto option expanding it to full screen. On infinity it is removed and becomes best fit and black bars are still there.

Is there a way to change this ?

 

[grog68]

check menu -> Setup - Video

 

[abp1873]

check menu -> Setup - Video

I think I have tried every setting in there mate and still struggle , unless there is a specific way it needs set up ?

 

[formandvoid]

In video settings I have mine set as below

Automatic resolution - disabled
Mode - 1080p
Refresh rate - 50hz
Display 4.3 - pillarbox
Display 16.9 - letterbox
Allow unsupported modes - no

If that 's not good try setting pan and scan where it says pillarbox and letterbox

Also you could turn off anything to do with auto settings on your tv

Other than that just expand it via your tv.