Thanks , however i don’t have a refresh rate setting in either basic video settings or extended?It's the refresh rate which is set to auto, go into video settings and switch from refresh rate auto to either 50hz or 60hz for no picture loss.
IF i remember rightly there was a problem with using sd cards and I dont think it ever got fixed. Have you no usb at all to use? If its stuck in a loop reflash it again but dont let it scan for channels. Select scan later manually as infinity scans for the channels right at the end. This could be causing the blue screen crash.have got a new H2H connected to Virgin.
clean box, followed the instructions to install infinity (installed OATV 6.2 build, then installed infinity via openwebif).
all good so far, it went thru the setup, scanned channels, then got to the part where it asked about usb storage for recording. i don't have external USB storage but have a micro SD card installed, let it continue and it said it found no storage device, then it crashed with blue screen and rebooted and seems to be stuck in that loop now.
if i select EXIT at that point is drops me out to OATV and seems to bailed out of the infinity setup.
i have no ABM, no cams.
where have i went wrong?
do i need to start from scratch? and if so, how do i get past the storage section if i don't have a USB device connected (i'm not bothered about recording, the micro SD was just for EPG and cache file data)
Yes, I clicked 'satellite only'. As I see it, it picks up the feed automatically but only found 'Tuner A: Tuner3-T/T2(T/T2/C'. And nothing connected to Tuners B and C.when you set infinity up did you click satellite if so it should of found it automatically
would not still work as i am using the new wooshbuild infinity ...ive put the lines in but nothing showing.put it on the box using filezilla or usb cam importer in wb config