1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.


Discussion in 'Vu+ UNO Support' started by chomper5000, Aug 25, 2017.

  1. chomper5000

    chomper5000 Member


    Can someone let me know how to setup autobouqet in Vix (version May 2017) for VM cable please? I have done the below so far but no channels are showing or playing:

    1. Enabled the tuners on VU+ Uno 4K
    2. Scanned channels and received 600+ channels
    3. Set the VM net ID

    I'm new to Vix. Please Help!

  2. ste

    ste TK Veteran Forum Supporter

    You say no channels are showing but then go on to say you've scanned and got 600+ channels - please can you confirm?

    Have you installed a VM gift line? ... only the SD versions of channels 1-5 will work until you purchase a VM specific line and put that onto the box.
  3. bangord30

    bangord30 TK Veteran

    And you will need to use OScam too.

    Sent from my HUAWEI VNS-L31 using Tapatalk
    wilsock likes this.
  4. chomper5000

    chomper5000 Member

    When doing a scan the scan shows 600+ channels but when viewing channels nothing displays also the EPG is blank. The EPG shows but no channels are listed. What am I doing wrong?

    Do I need bouquets and what else needs setting up please? Oscam is installed in the Vix image and it is enabled but im not sure if it is configured properly? I had to create the oscam.sever config file because it was not in the original image even though Oscam was installed.

    Please help.
    Last edited: Aug 26, 2017
  5. ste

    ste TK Veteran Forum Supporter

    Check if you're getting channels 1-5 in SD (HD ones wont work) ... if you get these, it's a line issue.

    You'd need to use a plugin to load the EPG like EPG Importer.

    I don't have and have never used this model box so it's slightly different to what i'm used to.
  6. chomper5000

    chomper5000 Member

    Thanks for the quick reply Ste. I will check the SD channels and install EPG importer. How do you use EPG importer by the way please? Thanks.
  7. ste

    ste TK Veteran Forum Supporter

    Check my H2.H setup guide in my sig for configuring it.