Hi,
Firstly to everyone that replies on these threads THANK YOU VERY MUCH.
I've gone through quite a few threads to see if my problem is answered elsewhere and the time and effort you put in to help others is incredible!!!!
My issue....
I've bought a second hand Zgemma H.2s with just 1 aim.....to watch and record RPGTV FREESAT service on channel 250.
I plugged the box in and did an auto-tune (The Installation Wizard didn't launch) which brought up about 800 channels. However channel 250 was showing SKY Food Network +1.
I went through every channel manually and the RPGTV channel was not there. I re-scanned a couple of times but RPGTV still wasn't there.
So unfortunately I then thought I'd start from scratch and did a factory reset........which crashed :-(
I've turned the box off and on again and all that happens is the box display says “boot” then the box display goes from 0 to 100 once before then going “0, 50, 75, 76, 78” a few times and then settling at “00” and doing nothing else.
Has the factory reset crash completely ruined the unit? (I've seen people talking about "re-flashing" but I don't know what that is or even if it's relevant here!!!
It's been a painful 5 hours of scanning, checking, googling and now finally the box has crashed so any help very gratefully received!!!
Firstly to everyone that replies on these threads THANK YOU VERY MUCH.
I've gone through quite a few threads to see if my problem is answered elsewhere and the time and effort you put in to help others is incredible!!!!
My issue....
I've bought a second hand Zgemma H.2s with just 1 aim.....to watch and record RPGTV FREESAT service on channel 250.
I plugged the box in and did an auto-tune (The Installation Wizard didn't launch) which brought up about 800 channels. However channel 250 was showing SKY Food Network +1.
I went through every channel manually and the RPGTV channel was not there. I re-scanned a couple of times but RPGTV still wasn't there.
So unfortunately I then thought I'd start from scratch and did a factory reset........which crashed :-(
I've turned the box off and on again and all that happens is the box display says “boot” then the box display goes from 0 to 100 once before then going “0, 50, 75, 76, 78” a few times and then settling at “00” and doing nothing else.
Has the factory reset crash completely ruined the unit? (I've seen people talking about "re-flashing" but I don't know what that is or even if it's relevant here!!!
It's been a painful 5 hours of scanning, checking, googling and now finally the box has crashed so any help very gratefully received!!!