ste
TK Veteran
Hello all,
I'm looking for some help to try and find out why my H2H is struggling to power my motor. Before I mounted the dish, with the motor still in the house, I plugged the motor into the receiver using a 2m length of cable - the motor powered up fine and moved using the buttons. Today, I mounted it to the house and wired it up (there's around a 10-15m cable run) but it struggled to power up - there was a light on there (motor) briefly which went out when i pushed a button on the motor then it lost power. I tried with the lnb (0.1db) plugged in and unplugged so that wasn't drawing any power from it but still the same both ways.
I'm using Wooshbuild OpenATV image.
I have seen the same issue faced by other people but can't find a solution.
TIA
I'm looking for some help to try and find out why my H2H is struggling to power my motor. Before I mounted the dish, with the motor still in the house, I plugged the motor into the receiver using a 2m length of cable - the motor powered up fine and moved using the buttons. Today, I mounted it to the house and wired it up (there's around a 10-15m cable run) but it struggled to power up - there was a light on there (motor) briefly which went out when i pushed a button on the motor then it lost power. I tried with the lnb (0.1db) plugged in and unplugged so that wasn't drawing any power from it but still the same both ways.
I'm using Wooshbuild OpenATV image.
I have seen the same issue faced by other people but can't find a solution.
TIA