Help H2 Flash

[bobby2good]

Ok so ive just tried to flash zgemma H2 with sucmnsee immage, started ok then had screen message = Error - tune failed. Any ideas chaps please

---------- Post Merged at 09:34 PM ----------

uPdate, my fualt , has flashed but was looking to scan but did'nt have cable inlol

---------- Post Merged at 10:31 PM ----------

update , now when i try to scan for channels it stops and says "cannot read data". I have entered my test nline. I am following an idiots guide for the process but it only says about loading sly autobouquets not vermin, is it the same process?. any help appreciated.

 

[bazwilson]

i am having similar problems if anybody can help

 

[baldwin101]

which image did you use?

 

[Jedit1]

If I'm not mistaken sucmnsee immage is set up for sky. Its probably Tuner B is off or Tuner A is on and can in some cases cause an issue. Try turning Tuner A off.
Also, do you see any free to air channels?
I did post a Image setup for Cable on the H2 as I had trouble finding a good image to run myself, however, I did not test with a nline but believe CCcam can use both.