When I scan via ABM I get an error unable to scan tuner c please check it is configured correctly.
When i do a scan but not via ABM no channels found.
I live in Oswaldtwistle nr Accrington
Hi,Interesting about the ABM scan.. It means that you either :
A) don't have the correct region set in ABM / Providers.
B) have a problem with your coax cable
But due to the fact your channel scans are returning nothing.. I'd suggest it's your coax cable myself. Can you confirm that you have the virgin coax cable going into the RF port on the box? Either naturally or by the coax to RF adapter?
I'll assume the H2H is working and has the correct info on it, in ABM and Tuner Config for example?Hi,
I would normally agree but when i disconnect the h5.2tc and connect my h2h using the same cable it works with no problem.
Yes the cable is connected correctly and i have also tried a new RF adapter but still no joy.
On the back of the H5.2TC there is only two connectors one for Sky and one for Virgin
Hi,
I would normally agree but when i disconnect the h5.2tc and connect my h2h using the same cable it works with no problem.
Yes the cable is connected correctly and i have also tried a new RF adapter but still no joy.
On the back of the H5.2TC there is only two connectors one for Sky and one for Virgin
Hi,
I would normally agree but when i disconnect the h5.2tc and connect my h2h using the same cable it works with no problem.
Yes the cable is connected correctly and i have also tried a new RF adapter but still no joy.
On the back of the H5.2TC there is only two connectors one for Sky and one for Virgin
Yes the H2H is working with no problems. Also no problems with the ABM. I am starting to think maybe a problem with the H5.2TC.I'll assume the H2H is working and has the correct info on it, in ABM and Tuner Config for example?
I'd suggest you flash with the image I sent to your inbox, then maybe use the H2H as a guideline to adjust the region in ABM / Providers (if you need to). I'd say the Tuner Config in my setup will work for you too with me being in Manchester myself..
i will give it a try when i get home thanks. But i am quite sure i have already done this but will checkIn tuner configuration, make sure it's set to virginmedia all systems
go to service searching>manuual scan
scroll down to 'type of scan' and go left/right until it says 'complete'
then click green button to perform a scan
i will give it a try when i get home thanks. But i am quite sure i have already done this but will check
you need the image for H5.2tc, not H3.2tcHi guys,
Just like to say thanks for everybody’s help.
The box is now up and running.
I was unable to flash using the H3.2tc the box just wouldn’t except it.
Did a complete scan and it found all the channels.
Decided to reinstall wooshbuild and everything started to work.
Once again thanks.
Best regards
Pintpot