[reader]
label = Grog_Line
enable = 1
protocol = newcamd
device = SERVER,PORT
key = 0102030405060708091011121314
user = USERNAME
password = PASSWORD
connectoninit = 1
caid = 1841
group = 1
emmcache = 1,3,2
blockemm-unknown = 1
Oscam and.cable lines dont get on
they get on perfectly well, I've used oscam on cable for couple of years now without an issue and have installed on lots of boxes for others. If you have an issue running oscam then it's more than likely a provider issue or settings in the oscam fileOscam and.cable lines dont get on.
If your box can run mgcamd, most boxes and buulds can now, use that instead of oscam
I meant Oscam isn't good for cable servers, some providers don't allow it at all.
It's not really required now that mgcamd runs on all boxes and builds and is easier on the servers, oscam causes too many conflicts server side
Why have you got 2 softcam panels/managers. I have one but it's accessable via two routes, menu -> infopanel -> Softcam Setup, or menu -> Setup -> Decryption & parental control -> Softcam SetupIt's since the C lines have been moved to etc folder, never managed to get one to work since then
Using atv6.2 and GBFR
I have 2 softcam panels/managers
If i go to softcam panel, I can use mgcamd1.38
if i use softcam-setup After (disabling mgcamd in panel) CCcam doesn't work