well , My Vu solo 2 stucks on " starting.. " I had flashed openatv 7.1 online via software management and after it has flash completed , I had to choice to install dual boot or exit . I tried to exit , but the hourglass kept turning and turning, so at the end I just switched the power off, I need to say , I have a usb stick which I use as HDD, so when I turned the power switch back on , I got "starting .." directly , and stayed like this for an hour, I shut down the solo 2 and then I took the usb in the back out , then I got a new image and try to flash it via the front USB, normally I should get the info " press power " to launch the new image , but it shows starting.. directly , if I press the power button directly after switching the power on , I see that the front USB is shortly switched on , but " starting .. I tried 2 different USB sticks ---- is still shown again , is there a hard reset somewhere , since it has not booted yet , could it be, that I have installed a dualboot ? without me knowing it ? I have seen some discussions to flash a old bootloader ? , well I do not know what to do
tx for any help , I hope my box is not a total lost ?
tx for any help , I hope my box is not a total lost ?