What's new
By:
Filters

vu solo 2 wooshbuild

S

sooty

Newbie
hi
I have reflashed vu and it gone onto wooshbuild v 6,000
I have my line on usb stick I have gone into usb cam importer v 3.00 it says import a line
or backup a line already on box have tried these but cannot get cam working
I have been into softcam panel select cam 1 cccam 2.0.9
it says active cam 1 cccam 2.0.9 I have restarted cam It say no ecm info
when I was on older version on wooshbuild it was working ok using usb but the setup on
new version is different
any help please
thank you
 
Hi
Have changed to 2.3.0
Still not working someone said that ccam has to have a tick to say active
Thanks
 
Yes the tick indicates the cam is enabled, so that is fires up everytime you use it, so if its not enabled...then enable it m8, usually with one of the coloured button showing down at the bottom of the page
 
Have tried restart green button says starting cam 1
Can 2.3.0 says active cam1:
Cccam but no green tick
When was on wooshbuild v5
Working ok I just copied file to sub and installed on sub cam importer
Thank you
 
further to above post
Have tried restart green button says starting cam 1
Can 2.3.0 says active cam1:
Cccam but no green tick
When was on wooshbuild v5
Working ok I just copied file to usb and installed on usb cam importer
Thank you
 
You must log in or register to reply here.
Back
Top