ZGemma H2s not recognising external HD after upgrade to WB6

[David in Spain]

Morning All. I have just upgraded a pal´s H2S from Wooshbuild Ver 3 to Ver 6. I had to do a factory reset and start from fresh using a USB stick. He used a ITB external drive for recording stuff and it worked fine. I sadly assumed that the 1TB external would be recognised when I plugged it in again after the upgrade. Any thoughts on how I can find it and use it without a new initialisation of the drive. Hope somebody can help. Many thanks. David

 

[bigwayne1976]

hi mate when did u plug in the hard drive?did u run the flash thru usb then swap over before going any further?

 

[wullboy]

Remount the drive, as it may not be getting recognized...

 

[David in Spain]

hi mate when did u plug in the hard drive?did u run the flash thru usb then swap over before going any further?

No , I set everything up and then tried. I have just been fiddling and found the mount and remount so will be forwarding that to my pal.

 

[David in Spain]

Remount the drive, as it may not be getting recognized...

Many thanks. I found this myself a few minutes ago. I will forward to my pal.