What's new
By:

"idiots guide" to installing sucmnsee's image with EVERY step explained in detail

eccoboy said:
Thanks very much for your help, that's really helped a lot, still managed to edit the cccam with the remote rather than FTP but all the lines are now there (it took a bit of scrolling down to find where they should go in the Etc folder but it is there!) Given I faffed with the nline area a bit do I need to go back and put it back as it was? (I took a photo before I messed with it!)
Hopefully everything now should work, just loading the epg on to a stick and then will reboot and try - will report back - fingers doubly crossed!!!!!

---------- Post Merged at 01:02 AM ----------

Ok, all the clines are in the cccam file on the etc. folder, however its stilll not working, any ideas on what to double check or look for or tests that I can run?
Thanks very much for your help!
Click to expand...

Did you disable mgcamd and start cccam
 
IMG_0571.JPG
Hi, I noticed that there wasn't anything there to enable or disable, it stated 'no ecm'
I've seen on another thread that I need CCcam 2.3.0 so I've just downloaded that and rebooted, however still no luck, please help!!!
 
Last edited:
Looks like your doing it in Ts panel Disable it in there press blue button on remote , softcam manager enable CCcam in there and start Also make sure you disabled your lines in newcamd list file as this will cause conflict. When you have started CCcam go to CCcam info , Servers you should see your lines


Sent from my iPhone using Tapatalk
 
Hi Tich, thank you for your reply. How do I disable it exactly (the blue button only gives me 'install')
Also where do I go to disable the lines in newcamd list?
Sorry to be so thick, just need guidance!
 
Think its red button to stop in Ts panel ( never use it ) In newcamd list files usr/Keys make sure your lines are not in there as having in both will cause conflict
 
ok, nothing in the newcamd at all now so that's clear of all entries.
I pressed the yellow button on the softcam manager and it shows the servers however they are all showing red......
 
Did you restart CCcam in softcam manager and reboot box ? What i find easier is if just using CCcam or Mgcam is remove the 1 you are not using Via Plugins, (red button )Remove plugins, Softcams that way you only have the 1 you are using
 
Hi yes I restarted and then rebooted, also just deleted the Mgcam in plugins too.
The CCcam I have listed is CCcam 2.3.0 - is that correct?
 
I've had my boxes working with the SoftCam plugin enabled in TS Panel like you show above, but you'll also need it enabled in SoftCam Manager within the main menu/setup. Then you need to add your line details via ftp or file manager - are you up to speed with doing is?
 
Having your box running in both causes problems better of using softcam manager


Sent from my iPhone using Tapatalk
 
Hi have followed all steps, when I put on paid channels it doesn't even go to them, example bbc1 working fine try to change to sky sports it just feezes on BBC 1 .... Any ideas what's wrong???

Sent from my UMI C1 using Tapatalk
 
You must log in or register to reply here.
Back
Top