jdsour
Member
You should have more options than that. Try do a system update
VM ROI
- Thread starter xyxy
- Start date
chrisc1982
Member
Got my channels scanned in but where abouts is the PPV channel as the fella I got line off said it included PPV
Cheers, I'll have a look when I get home. I've been reading over some of the threads today and have taken notes so hopefully I get it sorted later.
dsayers2014
VIP Member
Go in autobouquetmaker configure and change mode from simple to expert
Check in the 'Red Button' bouquet
Cortina
Newbie
Hi, sorry for butting in here, But, in in Kildare, Iv a basic cable feed, and a Dreambox 500c which Iv not used in a few years, I went Sat, is there anyway to set up a 500c with a line to get it running again.
The image on it is from 2011 so ill need a new one. Iv searched and from what I read, it should be possible, but can't seem to find any recent tutorials on how to do it. Any help appreciated.
Slaintè.
C.
The image on it is from 2011 so ill need a new one. Iv searched and from what I read, it should be possible, but can't seem to find any recent tutorials on how to do it. Any help appreciated.
Slaintè.
C.
Right, I've done a scan on 43217/291000/6887/Qam 64 and pulled in 261 TV and radio channels, would that be close to what I should be getting?
Only found 3 or 4 channels clearing but the picture is very jumpy and sound is very tinny, would that be a cable quality issue?
In abm I'm still only getting virmin UK area 47253 dublin :( and that's after a software update, will I need to flash the box with an up to date image?
Sorry for being such a pain with all the questions but I'm new to all this.
Only found 3 or 4 channels clearing but the picture is very jumpy and sound is very tinny, would that be a cable quality issue?
In abm I'm still only getting virmin UK area 47253 dublin :( and that's after a software update, will I need to flash the box with an up to date image?
Sorry for being such a pain with all the questions but I'm new to all this.
jdsour
Member
The signs are looking good, I'd say you cable could be an issue alright or if you're using a splitter could be that too. A new image maybe your only answer for ABM.
Yeah I'm using a splitter but don't really have any choice.
marconi_pete
Member
Try using a signal booster. It may help matters.
jdsour
Member
What type of splitter is it?
BZT?
5-1000 MHZ.
jdsour
Member
Should be grand, how are the connections on the cables?
I hooked it up to the TV in the other room earlier that has the original VM cable running in to the VM router, split that and ran it in to the Edison and I picked up 313 TV and radio channels and the ones that are clearing are much better, not jumpy at all.
jdsour
Member
There ye go, dodgey cable from the sound of it, new cable is you best bet