What's new
By:

Cannot read data error - H5.2TC

I rescanned with tuner a and b enabled. Then enabled tuner c and zap back to service.

Tuner A: 93% 38.0 db
Tuner B: 94% 38.0 db
Tuner C: 92% 38.0 db
 
there have been a few reports of failing tuner C's on the H5.2tc, Disable Tuner A & B and enable Tuner C making sure it has the same settings as Tuner B had, especially the Net ID and then run a manual scan. If it fails then chances are it's the tuner
 
grog68 said:
there have been a few reports of failing tuner C's on the H5.2tc, Disable Tuner A & B and enable Tuner C making sure it has the same settings as Tuner B had, especially the Net ID and then run a manual scan. If it fails then chances are it's the tuner
Click to expand...

Manual scan complete 0 channels found.
 
Could it be that whooshbuild isn't compatible? What would be the next best image to use to test this theory?
 
Yaz86 said:
Could it be that whooshbuild isn't compatible? What would be the next best image to use to test this theory?
Click to expand...

The build shouldn't make a difference, you could try another from the downloads section but can't personally see it solving the issue.
 
You must log in or register to reply here.
Back
Top