zgemma box h2s - n-line not working

[ollycuff]

I'm not quite sure which build as I bought it off someone just under 1 year ago .

 

[garyth]

are you running the line on mgcam or cccam?

 

[ollycuff]

mgcam 1.38

 

[garyth]

mgcam 1.38

Go into the keys file and delete the mgcam_cfg file then add the one from here Mg_cfg file and put it in keys and save file, now restart the mgcam in softcams

 

[ollycuff]

thank you , it is now working . thank you ALL very much .

 

[garyth]

thank you , it is now working . thank you ALL very much .

Christ that was epic lol

 

[ollycuff]

hmm , it has now stopped again . I have stop and started the cam again but has not come back on ? it was all abit jumpy to

 

[garyth]

hmm , it has now stopped again . I have stop and started the cam again but has not come back on ? it was all abit jumpy to

where did you get your line/gift from? as in ebay or from here on the forum from someone? If from the forum do not mention names please

 

[garyth]

hmm , it has now stopped again . I have stop and started the cam again but has not come back on ? it was all abit jumpy to

double post, edited

 

[ollycuff]

it has been a guy I have used before online . it was fine for the full year never had any problems until I came to renew the gift .

 

[garyth]

it has been a guy I have used before online . it was fine for the full year never had any problems until I came to renew the gift .

I would be contacting him and asking what the issue is?

 

[bacardi]

Ask for a test off here or get someone to test it for you