Start the receiver in console mode, it should show the error. Use following commands (putty or any terminal client) one at a time, then post back result
I have also come across this issue on my H7, as per your pictures I got the same with the certificate thing (i presume that was the fault?) when doing an update and then it got stuck in a boot loop ending in a freeze.
The way i got round this (and shows the importance of a full backup) was to use Recovery Emmc - I used Openvix 6 6 001 Release Zgemmah7 Recovery Emmc
This worked fine and installs the basic image after, then i went into menu/setup/vix/image manager and flashed the stored full image backup and all working fine. I think as Willo said it was a glitch, but I had it too.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.