WilloBuild WilloBuild OpenViX 6.7 Series

[Willo3092]

access the box with putty and issue 'reboot' command and see if it starts now.

 

[Armani_Vision]

Sadly that hasn’t worked. It’s now just a black screen without the image as previous post

 

[Willo3092]

power off and on again 🤔

 

[Armani_Vision]

Still nothing

 

[Willo3092]

Have you got another way of watching TV for tonight? I'm getting grief here

 

[Armani_Vision]

Yeah 😅 thank you for your assistance so far

 

[Abu Baniaz]

Start the receiver in console mode, it should show the error. Use following commands (putty or any terminal client) one at a time, then post back result

init 4
Enigma2
(Might be lower case)

 

[southsimon]

Have you ever come across the below ? I can’t seem to get it to work. Zgemma H9S

I have also come across this issue on my H7, as per your pictures I got the same with the certificate thing (i presume that was the fault?) when doing an update and then it got stuck in a boot loop ending in a freeze.

The way i got round this (and shows the importance of a full backup) was to use Recovery Emmc - I used Openvix 6 6 001 Release Zgemmah7 Recovery Emmc

This worked fine and installs the basic image after, then i went into menu/setup/vix/image manager and flashed the stored full image backup and all working fine. I think as Willo said it was a glitch, but I had it too.