I need to enter the line in Blade 700os but I could not figure out how to write N: as : is not in the box editor keyboard. The address is like N: ga***.net
I need to enter the line in Blade 700os but I could not figure out how to write N: as : is not in the box editor keyboard. The address is like N: ga***.net
Just make sure you change the "Protocol" to "Newcamd" instead of "Cccam" using the left and right arrows on the remote. Then add the rest of your line in the correct places. No need to actually put the "N" in front of the address. Hope that helps.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.