load gift with usb

[dave100]

back again. loaded the n file it shows in- usr= keys- but does not show the mgcamd instead it shows mg...cfg, when I press it shows the nline is there but, doesent clear the picture.

Try these mate :)

https://mega.nz/#!id1B2DiZ!ALwdd25-3CT5A5Fmme3XMvYY6qMERMdsOHgX2-vGeG8

 

[bold]

thanks mate, and how doi put the line in the folder, will I have to use filezella to put it in.

 

[bold]

sorry shall I put this on the usb and down load through usb plunger to store it on the box.

 

[wullboy]

Yes.. ftp over to the files, put your line in, save, then start your Cam, then go over to a premium channels and wait on it kicking in..

 

[bold]

ok mate ill try it later, thanks

 

[bold]

ok, iv loaded the above file. stracted and put it on usb put the stick in the box. but it doesn't load on to box, still says there are no files. nothing happens.

 

[formandvoid]

Here are some instructions if it helps

1/INSTALL MGCAMD ON YOUR BOX

2/ON BOX REMOTE CONTROL PRESS THE BLUE BUTTON AND SELECT SOFTCAM MANAGER.
MAKE SURE THERE IS A GREEN TICK BESIDE MGCAMD_138 THEN PRESS THE GREEN BUTTON ON YOUR REMOTE
YOUR CAM IS NOW ACTIVE,JUST PRESS EXIT BUTTON TO CLOSE.

NOW GO TO YOUR COMPUTER


YOU WILL NEED THE MG_CFG FILE AND THE NEWCAMD FILE YOU DOWNLOADED.



3/YOU FIRST NEED TO ENTER YOUR LINE DETAILS IN THE NEWCAMD FOLDER

OPEN THE NEWCAMD FILE WITH NOTEPAD

ENTER YOUR LINE DETAILS AFTER THE CWS = (LEAVING A GAP BETWEEN EACH PART OF YOUR CODE)

CWS = YOUR CLINE DETAILS 01 02 03 04 05 06 07 08 09 10 11 12 13 14

AND CLICK SAVE



NEXT THEN NEED TO FTP THE FOLDERS TO YOUR BOX


4/START FILEZILLA

IN HOST TYPE THE IP ADDRESS OF YOUR BOX

IN USERNAME TYPE ROOT

PASSWORD LEAVE BLANK

PORT LEAVE BLANK

AND CLICK ON QUICK CONNECT

YOU WILL THEN SEE YOUR BOXES FILES IN THE BOTTOM RIGHT HAND WINDOW

SELECT USER THEN KEYS AND NOW COPY THE FILES MG_CFG AND NEWCAMD FILES INTO THE KEYS FOLDER, OU CAN DRAG AND DROP THEM) INTO THIS DIRECTORY AND THAT'S IT YOUR CAM SHOULD NOW BE WORKING.(IT MAY ASK YOU TO SAVE IT,JUST CLICK OK)

 

[bold]

ok thanks, I have INSTALL MGCAMD ON BOX, 2/ON BOX REMOTE CONTROL PRESS THE BLUE BUTTON AND SELECT SOFTCAM MANAGER. done that. MAKE SURE THERE IS A GREEN TICK BESIDE MGCAMD_138. there is no green tick beside the mgcamd and it wont allow me to tick with green button . although it does say active cam1 mgcamd 1.38r1.

 

[formandvoid]

Maybe it's different but yes activate cam and it should work.

 

[bold]

thanks for all the help, I just reflashed the box and its up and running.