I've set my zgemma h1 as bees guide. I'm on openvix 3.2.007. I'm ok on the sat side, but cable is new to me. looking for the net id I get, net id 00015 freq 826250 symbol rate 6887 from the list on the forum.
so I set that up, tho not sure where to put the frequency and tried a manual scan for tuner b which is set to cable dvb-c, config mode - enabled, net id - 00015, used service scan type - freq bands, yes to all QAM, scan additional SR - 6887. green to save. a manual scan on tuner B finds 0 channels.
any idea on what I've got wrong? or things to check. just trying fta channels at the moment, I know theres just a few sd free on cable but no use getting a line until I can sort this out.
an automatic scan completes the sat, but gives error scanning as soon as its supposed to scan cable
if I go to signal finder, and look at tuner B, I can change freq to 826, and symbol rate to 6887, but get no signal and finds 0 on scan.
edit: seems to be ok now. I set everything else up as I wanted, tried the box today and all good so far.
so I set that up, tho not sure where to put the frequency and tried a manual scan for tuner b which is set to cable dvb-c, config mode - enabled, net id - 00015, used service scan type - freq bands, yes to all QAM, scan additional SR - 6887. green to save. a manual scan on tuner B finds 0 channels.
any idea on what I've got wrong? or things to check. just trying fta channels at the moment, I know theres just a few sd free on cable but no use getting a line until I can sort this out.
an automatic scan completes the sat, but gives error scanning as soon as its supposed to scan cable
if I go to signal finder, and look at tuner B, I can change freq to 826, and symbol rate to 6887, but get no signal and finds 0 on scan.
edit: seems to be ok now. I set everything else up as I wanted, tried the box today and all good so far.
Last edited: