Yes got everything backed up, once I had installed the image i got the splash screen up then it goes off I didn't take much notice as to the exact number it went off at but then the numbers continued to increase on the LCD display until it got to 100 then it went to the time, still not showing anything on screen, anytime I press anything on the remote it will display 0101 for a few seconds then go back to the time.
How do I backup my image to flash my setup should I need to start from scratch?
I've got it all setup how I want and just want to backup this to flash on another box basically
but im unable to see where to enter my line. i can see it in device manager but dunno where i have to enter it.
I am using Sucmnsee image. It takes about 2 minutes to load. How long does this image (mypockets) take to load. Thx
Cycles through the boot, up to 77 and then back to 00 again.
Now flashing back to this new image again and will hold off updating for the time being!
Any thoughts or help appreciated.
Im having same blank screen problem because im on a 720p tv, is there anyway i can press a few buttons and change this to 720p while blind?
Thanks @mtpockets. I thought I might be brave tonight and try another online update of your latest June image - but the Update Manager tells me that there are 46 packages to update but then " You're on an old version and an update may result in a box that won't boot etc etc"
Thank you Madi1234Well newcamd an cccam are same ftp newcamd detail on to cccam folder .
Sent from my SM-G900F using Tapatalk
Well, no drama until it updates telnetd - shuts down the telnetd that I'm connected via, and the upgrade seems to stop. Dunno if doing an "opkg upgrade &" would help - but have to reboot to get a telnet session back (ie to restart telnetd).
Thank you Madi1234Well newcamd an cccam are same ftp newcamd detail on to cccam folder .
Sent from my SM-G900F using Tapatalk
so I just install DL via usb and all will be there??[/QUOTE
CCCam and Newcamd are Not the same They are 2 different types of protocol A C/ine can only be used in CCcam A N/line can be used in CCcam and Newcamd list file in conjunction with a Mg file
N/lines work better in Newcamd list file