bees
VIP Member
CCcam can run C or N lines
Generally N lines are run in MGCamd as it is considered more stable. C lines can't use MG Camd.
So you need to put your C line in a file called CCcam.cfg that is then ftp'd the the ETC folder of your box.
When using CCcam you would just paste in a C or N line like so into the CCcam.cfg file
C: topserver 12100 tricky_user 123450
The equivalent N line would look like this (the numbers at the end are called a deskey)
N: topserver 12100 tricky_user 123450 01 02 03 04 05 06 07 08 09 10 11 12 13 14
Using MG Camd you would change the front end of your N line to read
CWS = topserver 12100 tricky_user 123450 01 02 03 04 05 06 07 08 09 10 11 12 13 14
Then paste it into a newcamd.list file then ftp to the var/keys folder in your box.
Generally N lines are run in MGCamd as it is considered more stable. C lines can't use MG Camd.
So you need to put your C line in a file called CCcam.cfg that is then ftp'd the the ETC folder of your box.
When using CCcam you would just paste in a C or N line like so into the CCcam.cfg file
C: topserver 12100 tricky_user 123450
The equivalent N line would look like this (the numbers at the end are called a deskey)
N: topserver 12100 tricky_user 123450 01 02 03 04 05 06 07 08 09 10 11 12 13 14
Using MG Camd you would change the front end of your N line to read
CWS = topserver 12100 tricky_user 123450 01 02 03 04 05 06 07 08 09 10 11 12 13 14
Then paste it into a newcamd.list file then ftp to the var/keys folder in your box.
Last edited: